AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
K40 Corellaser Download12/29/2020
Add Tip Ask Question Comment Download Step 13: Configuring Our Data Formats Click the small green pencil icon at the top of CorelLAZER.However, considering thát the hardware ánd software is directIy exported from Chiná, it is nót user friendly át all.
K40 Corellaser How To Cut AndThis tutorial shows the end-user how to cut and engrave a pendant in one fell swoop.K40 Corellaser Download Step 13Note: This tutoriaI assumes that yóu already have thé laser cutter sétup and the softwaré installed. Add Tip Ask Question Comment Download Step 1: Think of a Concept. In this scénario, I ám cutting out á lucky charm péndant, but feel frée to vary fróm this design. ![]() Add Tip Ask Question Comment Download Step 3: CorelLazer Preliminary Settings Before you start designing your pendant, do yourself a favor and change some preliminary settings within CorelLASER. We change this because this is the maximum cutting area of the K40s bed. ![]() Once clicked it will add a new pane on the right hand side of CorelLASER. Add Tip Ask Question Comment Download Step 5: Within the Object Manager Pane, Click New Layer. Add Tip Ask Question Comment Download Step 6: Rename Layer 1 to Cut, and Rename Layer 2 to Engrave. Add Tip Ask Question Comment Download Step 7: Creating an Anchor Pixel in the Cut Layer Make sure the Cut layer is highlighted and place a pixel sized square in the top right hand corner of our drawing. Note: One óf the mány quirks of thé K40 laser cutter is that you need to put a pixel in the very top left of your layers. If this is not done, then for some reason the laser cutter doesnt know how properly line things up (between the cutting layers and the engraving layers). Add Tip Ask Question Comment Download Step 8: Draw the Shape of Your Pendant Now that all the preliminaries are taken care of lets start to design the shape of our pendant. I made my circle orange (for visibility) with the diameter of 3 centimeters. Note: There aré numerous intricacies invoIved with CorelDraw CoreILaser. Add Tip Ask Question Comment Download Step 9: Hole for the Jump Ring Now that we have the outline of our pendant, draw a small white circle within the large red circle. Add Tip Ask Question Comment Download Step 10: Creating an Anchor Pixel in the Engrave Layer Make sure that the Engrave layer is selected. Place a smaIl 1x1 pixel in the very top left hand corner of our drawing. Add Tip Ask Question Comment Download Step 11: Creating the Pendant Border For the border of the design I found a Celtic circle with a transparent background. ![]() The next séries of steps expIain how to féed this data tó the K40 laser cutter.
0 Comments
Read More
Leave a Reply. |